DIY Belt Grinder

First version with 3D printed parts. Made from box section, angle and flat.


Box for single phase induction motor with mount that uses the weight of the motor for tensioning.

Added a welded stand.




With the belt grinder mounted

Guard for the pulley and belt at the top



 

Comments

Post a Comment

Popular posts from this blog

Automatic Centre Punch

Image
      Additionally three springs are required. I used 6x40mm compression springs. I put three together in the top and one on the firing pin. The one on the firing pin was cut down a bit and bent to the side, enough so the pin catches the hammer on the way up.
Read more